Toro Greensmaster eFlex 1021 Service Manual page 154

Assembling the Handle Assembly (continued)
Controls, Wheels and Accessories : Service and Repairs
5. Position the compression spring (6), spacer tube (13) and 2 bushings (3) into
the handle mount (7). Install the clutch bail assembly (4) to the handle mount
(7) and secure with the bolt (2) and flange nut (8).
6. If removed, install the LH and RH bail brackets (1 and 15) to the handle
(16) with the 2 screws (14).
7. Install the clutch bail assembly (4) to the handle (16). Secure the handle to
the handle mount (7) with the 2 bolts (17) and 2 nuts (8).
8. Position the spring spacer (Item 24 in
(23) into the handle adjuster assembly (22). Install the handle adjuster
assembly to the upper receiver weldment (8) with the clevis pin (14), bearing
washer (15) and cotter pin (18).
9. If removed, install the lift assist handle (27) to the upper receiver weldment
(8) and secure with the bolts (16 and 11).
10. Slide the upper receiver weldment (8) in to the lower handle assembly (19)
and secure with the bolt (29) and flange nut (9).
Note: Do not tighten bolt and nut. Install the nut to engage locking feature.
The upper receiver weldment (8) must be free to slide.
11. Reposition the wire harness.
12. If removed, install the flange bushings (5), bolt (12) and flange nut (13) into
the brake lever (6).
13. Position the brake lever (6) to the upper receiver weldment (8) and secure
with the shoulder screw (4) and flange nut (7).
14. Install the InfoCenter mount (item 4 in
with the 4 screws (1).
15. Install the wire harness.
16. If removed, install the flange bushings (item 31 in
throttle arm (1).
17. If removed, slide the throttle lever (34) onto the throttle arm (1) and secure
with bolt (32).
18. Torque tighten the bolt from 2.2 to 3.4 N·m (20 to 30 in-lb).
19. Install the throttle arm (1) to the handle assembly (3) and secure with bolt
(30), washer (2) and nut (20).
20. Install the bolt (21) and 2 flange nuts (7) to the upper receiver weldment (8).
Ensure that the head of the bolt is resting the on throttle arm (1).
21. Install the brake latch shaft; refer to
6–12).
22. Install the clutch and reel drive lever assembly; refer to
Cutting Unit Drive Lever Assembly (page
23. Install the reel cable; refer to
24. Install the brake cable; refer to
25. Install the throttle cable (27).
26. Adjust the traction bail proximity sensor; refer to
Proximity Sensor (page
27. Install the bottom control cover and re-position the wire harness to the upper
receiver weldment and secure with the 2 screw and washer assemblies, 2
bolts and 2 nuts.
Figure
Figure
Assembling the Brake Latch Shaft (page
6–10).
Installing the Reel Cable (page
Installing the Brake Cable (page
5–20).
Page 6–18
84) and handle torsion spring
85) onto the handle and secure
Figure 84) inside the
Assembling the
6–8).
6–5).
Adjusting the Traction Bail
Greensmaster ®
20248SL Rev A
eFlex 1021