Toro Greensmaster eFlex 1021 Service Manual page 196

Removing the Gear Box Assembly (continued)
Universal Groomer (Optional): Service and Repairs
You must use a 6-point socket with a heavy wall to remove the gear
box from the reel. Do not use an impact wrench. Groomer gear
boxes installed on the right side of the cutting unit use a standard
right hand thread; turn the drive shaft counterclockwise to remove
the gear box.
9. Rest the handle of the pry bar against the front roller and turn the drive shaft
counterclockwise to loosen it from the reel. Continue to unscrew the drive
shaft and remove the gear box from the cutting unit.
g285845
1. Socket head screw (4 each)
2. Gear box cover assembly
3. Cover gasket
4. Driven gear
5. Thrust washer
6. Ring gear
7. Flange bushing
10. If the hex head on the end of the drive shaft is damaged during removal:
A. Remove the drain/fill plug and drain the oil from the gear box.
B. Remove the 4 socket-head screws and remove the gear box cover
assembly and driven gear. Remove and discard the cover gasket.
C. Slide the thrust washer, ring gear and bushing from the gear box housing.
D. Slide the sun gear, and planet gears and bushings from the pins on the
gear box housing.
E. Remove the retaining ring from the drive shaft.
IMPORTANT
Figure 118
8. Sun gear
9. Planet gear (3 each)
10. Flange bushing (3 each)
11. Retaining ring
12. Gear box housing assembly
13. Damaged drive shaft
Page 8–6 Greensmaster ® eFlex 1021
20248SL Rev A