Toro Greensmaster eFlex 1021 Service Manual page 72

Disassembling the Transmission Gear Box Assembly (continued)
g339789
1. Short bearing pin
2. O-ring
3. Long bearing pin
4. Bearing spacer (2 each)
5. Retaining ring (4 each)
6. Ball bearing (5 each)
7. Spur gear
Traction and Reel Drive Systems: Service and Repairs
8. Flange nut (2 each)
9. Wave spring
10. Ball bearing (2 each)
11. Retaining ring (2 each)
12. Reel drive shaft
13. Square key (2 each)
14. Slider spur gear
14. Slide and remove the reel clutch actuator (item 16 in
transmission housing assembly (20). If necessary, remove the reel clutch
shoe (15) from the reel clutch actuator (16).
15. Remove the reel drive shaft assembly (12), ball bearing (10) and wave spring
(9) from the transmission housing assembly (20). If necessary, disassemble
the drive shaft assembly (12) as follows:
A. Use a press to remove the ball bearings (10) from the reel drive shaft
(12). Discard the bearings (10).
B. Remove the retaining ring (11) from the reel drive shaft (12).
Figure 26
15.
16.
17.
18.
19.
20.
Page 4–26
Reel clutch shoe
Reel clutch actuator
Spur gear
Thin lock nut
Input shaft
Transmission housing assembly
Figure 26) from the
Greensmaster ® eFlex 1021
20248SL Rev A