Toro Greensmaster eFlex 1021 Service Manual page 204

Installing the Idler Assembly (continued)
Universal Groomer (Optional): Service and Repairs
C. Install the bearing shields with flocked side of shield toward the bearing.
D. Check the idler arm orientation (left or right cutting unit) and insert the
stub shaft (item 9 in
through hole in the shaft to prevent shaft from rotating, tighten the flange
nut to 37 to 45 N∙m (27 to 33 ft-lb).
E. If the collar was removed from the idler arm, install the collar and tighten
to 33 to 41 N∙m (24 to 30 ft-lb).
2. Fit a new O-ring to the motor adapter.
3. Apply anti-seize lubricant to the outside diameter of the motor adapter and
position the idler arm over the adapter.
4. Use new lock nuts and secure the motor adapter and idler arm to the cutting
unit side plate.
5. Install the clevis pin and a new cotter pin to secure the height adjustment rod
to the front of the idler arm.
6. Install the reel drive; refer to
Figure 122) through shields and bearing. Use the
Installing the Reel Drive Assembly (page
Page 8–14
4–9).
Greensmaster ® eFlex 1021
20248SL Rev A