Toro Greensmaster eFlex 1021 Service Manual page 209

Assembling the Height Adjuster
Greensmaster ® eFlex 1021
20248SL Rev A
1. Apply anti-seize lubricant to the upper threads of the adjustment rod and
lower threads of the height adjusters. Assemble the height adjuster assembly.
2. If both the height adjusters are removed, fit 1 height adjuster assembly to the
cutting unit side plate and secure it with the carriage bolt and flange nut. Do
not tighten the flange nut at this time. Ensure that the height adjustment bolt
and 1 washer is above the slot in the side plate and 1 washer and locknut is
below the slot in the side plate.
3. Position front roller between the height adjuster assemblies and secure
height adjuster assembly to cutting unit side plate with carriage bolt and
flange nut. Do not tighten the flange nut at this time. Ensure the height
adjustment bolt and 1 washer is above slot in side plate and 1 washer and
locknut is below slot in side plate.
4. Center the front roller between the height-of-cut brackets and tighten the
front roller pinch bolts.
5. Install new cotter pins and clevis pins and secure the height adjustment rods
to the groomer gear box and idler arm.
6. Adjust the cutting unit height-of-cut; refer to Cutting Unit Operators Manual.
7. Check the groomer reel height and adjust as necessary.
8. Adjust the flange nuts on the groomer height adjustment rods until the
springs are compressed to 19 mm (0.750 inch).
g317116
Figure 126
Page 8–19 Universal Groomer (Optional): Service and Repairs