Toro Greensmaster eFlex 1021 Service Manual page 170

Installing the Bedbar
DPA Cutting Units: Service and Repairs
g226763
1. Side plate
2. Rubber bushing
3. Nylon bushing
4. Plastic washer (2 each)
1. If rubber bushing (item 2 in
apply grease to outside surface of new bushing and install into side plate
(1). The bushing (4) should be installed flush with the inside surface of the
side plate; refer to
2. If removed, install the nylon bushings (4) with flange facing outward; refer
to Figure 99.
3. Apply anti-seize lubricant to the threads and shank of each bedbar bolt (7);
refer to Figure 99.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when handling the bedbar.
Note: If a new bedknife is attached to the bedbar, there may be interference
between the bedknife and the reel when installing the bedbar. Turn the
bedbar adjusting screws counterclockwise to increase bedknife clearance
if necessary.
4. Position the bedbar assembly (8) into the cutting unit. Make sure that the top
of each bedbar arm is between the washer (9) and adjuster screw flange (7).
When installing the washers, make sure that the plastic washers (6
and 15) are positioned against the side plate.
5. Position one plastic washer (item 4 in
and each side plate (1).
6. Slide a metal washer (item 5 in
Figure 99
5. Metal washer
6. Bedbar
7. Bedbar pivot bolt
8. Lock nut
Figure 99) was removed from either side plate,
Figure 99.
CAUTION
IMPORTANT
Figure
Figure 99) onto the bedbar bolt (7).
Page 7–6
99) between the bedbar (16)
Greensmaster ®
20248SL Rev A
eFlex 1021