How To Connect Connectors - Toshiba TH850A Instruction Manual

Opposite connector type
Type of connector: JOEP
Type of contact:
JOFP
JOFS
Disconnect.
(CN4 side)
4.1.1

How to Connect Connectors

The motor cover of the dust- and drip-proof type robot base is equipped with a cable
clamp (dust- and drip-proof construction). To connect the cables from the separate
PLC, etc., use this cable clamp to connect them with the connectors in the robot.
For the cable clamp, use a cable with shield, whose outer diameter is 6.0 to 12.0 mm.
Cable clamp
Filler
Cover
(rubber)
Rubber
bushing
DUST- & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
SMR–07V–B (Maker: J.S.T. Mfg.)
JOFP SMR–06V–B (Maker: J.S.T. Mfg.)
BYM–001T–0.6 (Maker: J.S.T. Mfg.)
JOEP
JOES
JOES JOFS
Fig. 4.1 Wiring to PLC, etc.
To be soldered.
Cap
Connectors
(JOFS, JOES)
Fig. 4.2 How to connect connectors
– 30 –
From PLC, etc.
Motor cover
Cable inlet
Cable clamp inner dia. 12 mm, 1 place
Rubber bushing
From PLC, etc.
User cable
STE 80765