Installation; Installation Environment - Toshiba TH850A Instruction Manual

3.

Installation

3.1

Installation Environment

Table 3.1 shows the environmental conditions for the location in which the robot and
controller are to be installed.
Table 3.1 Environmental conditions for robot and controller
Item
Temperature
Humidity
Altitude
Vibration
Dust
Gas
Sunlight
Power noise
Magnetic field
Dust-proof and
drip-proof
• Do not place the robot or controller near combustible. Doing so could lead
to fires if it ignites due to a fault, etc.
DUST- & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
In operation : 0 to 40°C
In storage : –10 to 50°C
20 to 90 % (Non-condensing)
1000 m or less
In operation : 0.98 m/s
No inductive dust should exist.
No corrosive or combustible gas should exist.
The robot and controller should not be exposed to direct sunlight.
A heavy noise source should not exist nearby.
A heavy magnetic field source should not exist nearby.
Any place where the equipment sinks in liquid shall not exist.
Small chips involved in turning or cutting operation shall not be
contained.
Mist of cutting fluid or coolant oil shall not be contained.
!
– 20 –
Specifications
2
or less
DANGER
STE 80765