System Configuration Of The Optical Reader As Profinet Io Device With Switch And Fb 79 Or Ident Profile - Siemens SIMATIC MV500 Operating Instructions Manual
Hide thumbs
Also See for SIMATIC MV500:
- Operating manual (148 pages) ,
- Operating instructions manual (236 pages)
Table of Contents
Advertisement
4.3 System configuration of the optical reader as PROFINET IO device with switch and FB 79 or Ident profile
• The optical reader is controlled via PROFINET IO/PROFIBUS DP-V1 using the Ident profile
block by the S7 controller.
• The result is output via PROFINET IO/PROFIBUS DP-V1 to the S7 controller.
• The optical reader is supplied with power via the communication module.
• The optical reader is triggered either via digital I/O, S7 controller or via the built-in auto-
trigger function.
• A PC/PG is connected via the Ethernet interface to allow adjustment of the device.
4.3
System configuration of the optical reader as PROFINET IO device
with switch and FB 79 or Ident profile
Note
Power supply using "Power over Ethernet" (PoE)
If the optical reader is supplied by PoE, for example when connected to a
SCALANCE X108POE, the Power IO RS232 cable is not needed.
SIMATIC MV500
Operating Instructions, 03/2021, C79000-G8976-C494-05
Network and system integration
95
Advertisement
Table of Contents
