Toro Reelmaster 5010-H Operator's Manual page 14

Positioning the Turf Compensating
Spring
Cutting Units 2 and 4
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
1. If the hairpin is installed in the rear hole of the
compensation-spring rod—remove the hairpin
and insert it in the hole next to the bracket
(Figure 10).
Figure 10
1. Hairpin
2. Remove the 2 flange locknuts (3/8 inch) and 2
carriage bolts (3/8 x 1-1/4 inches) that secure
the turf-compensator bracket to the cutting-unit
frame (Figure 11).
Figure 9
5. Cutting unit 5
6. Reel motor
7. Weight
g378839
1. Carriage bolt (3/8 x 1-1/4
inches)
2. Turf-compensator bracket
3. Remove the flange locknut (3/8 inch) that
secures the capscrew of the turf compensation
spring to the right tab of the carrier frame,
and remove the compensation spring from the
cutting unit
Note:
Do not remove the flange serrated nut
from the capscrew.
1. Capscrew
2. Right tab (Carrier frame)
4. Assemble the capscrew of the turf compensation
spring to the right tab of the carrier frame
g375689
13) with the flange locknut (3/8 inch).
14
Figure 11
3. Flange locknut (3/8 inch)
(Figure 12).
Figure 12
3. Flange locknut (3/8 inch)
g375690
g375691
(Figure