Toro Reelmaster 5010-H Operator's Manual page 71

Preparing the Machine
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. With the engine off, but the key in the run
position, access the Main Menu of the
InfoCenter.
3. From the Main Menu, scroll down to Service
Menu using the center button and select it using
the right button.
4. In the Service Menu, scroll down to Front
Backlap, Rear Backlap, and activate front, rear
or both by using the right button to turn the
desired set of cutting units from O
5. Press the left button to save the settings and
exit the Settings menu.
6. Make initial reel-to-bedknife adjustments
appropriate for backlapping on all cutting units
which are to be backlapped; refer to the cutting
unit Operator's Manual.
Lapping the Reels and Bedknife
1. Start the engine and run at low idle speed.
DANGER
Changing the engine speed while
backlapping may cause the reels to stall.
• Never change the engine speed while
backlapping.
• Only backlap at idle engine speed.
2. With the Mow/Transport lever in the M
position, move the Enable/Disable switch to
the E position. Move the Lower Mow/Lift
NABLE
control forward to start the backlapping operation
on the designated reels.
3. Apply lapping compound with a long-handled
brush.
Important:
Never use a short-handled
brush.
4. If the reels stall or become erratic while
backlapping, select a higher reel speed setting
until the speed stabilizes, then return the reel
speed to your desired speed. This can be done
using the buttons on the InfoCenter.
5. If you need to make an adjustment to the cutting
units while backlapping, perform the following
steps:
A. Moving the Lower Mow/Raise lever
rearward and press the Enable/Disable
switch to DISABLE position.
43).
6.
Finishing Backlapping
1.
2.
to O .
FF N
3.
4.
5.
6.
7.
OW
71
B. Shut off the engine and remove the key.
C. Adjust to the cutting units.
D. Repeat steps 1 through 3.
Repeat step 3 for the other cutting units that you
want to backlap.
Moving the Lower Mow/Raise lever rearward
and press the Enable/Disable switch to D
position.
Shut off the backlap functions using the buttons
in the InfoCenter.
Important:
If you do not return the backlap
function to the O setting after backlapping,
FF
the cutting units do not raise or function
properly.
Shut off the engine and remove the key.
Wash all lapping compound off from the cutting
units.
For a better cutting edge, run a file across the
front face of the bedknife after lapping.
Note:
Burrs or rough edges may result from
lapping the cutting edge. For a better cutting
edge, file across the cutting edge 90º to the front
face of the bedknife to remove the burrs.
Adjust the cutting unit reel to bedknife as
needed.
Adjust the cutting unit reel speed to the desired
mowing setting.
ISABLE