Replacing A 48 V Cutting Unit Fuse; Replacing The Reel Enable Fuse - Toro Reelmaster 5010-H Operator's Manual

4. Assemble the control-arm cover to the control
arm, and secure the cover with the 2 latches.
Replacing a 48 V Cutting
Unit Fuse
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood; refer to
Hood (page 43).
3. At the front, left side of the engine, remove the
cover for the 48 V fuse-block.
Figure 101
1. Cover
2. Maxi fuse
4. Replace the open fuse with a fuse of the same
type and amperage rating.
Note:
Refer to the decal on the cover.
43).
Opening the
g379036
3. 48 V fuse block
5. Assemble the cover to the 48 V fuse-block.
6. Close and latch the hood; refer to
Hood (page 43).
Replacing the Reel Enable
Fuse
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood; refer to
Hood (page 43).
3. At the front, left side of the engine, Remove the
cap from the in-line fuse holder labeled E
F 10 A 125 V.
USE
59
Figure 102
Closing the
43).
Opening the
g379037
NABLE