Single Point Adjust Cutting Unit; Bolt Cutting Unit - Toro Greensmaster 3200 Service Manual

Single Point Adjust Cutting Unit

Each cutting unit has (7) grease fittings that must be lu-
bricated regularly with No. 2 General Purpose Lithium
Base Grease.
The grease fitting locations and quantities are: Bedknife
pivot (1), Reel bearings (2), and front and rear rollers (2
ea.).
IMPORTANT: Lubricating cutting units immediately
after washing helps purge water out of bearings and
increases bearing life.
1. Wipe each grease fitting with a clean rag.
2. Apply grease until pressure is felt against handle.
IMPORTANT: Do not apply too much pressure or
grease seals will be permanently damaged.
3. Wipe excess grease away.

4 Bolt Cutting Unit

Each cutting unit has (6) grease fittings that must be lu-
bricated regularly with No. 2 General Purpose Lithium
Base Grease.
The grease fitting locations and quantities are: Reel
bearings (2) and front and rear rollers (2 ea.).
IMPORTANT: Lubricating cutting units immediately
after washing helps purge water out of bearings and
increases bearing life.
1. Wipe each grease fitting with a clean rag.
2. Apply grease until pressure is felt against handle.
IMPORTANT: Do not apply too much pressure or
grease seals will be permanently damaged.
3. Wipe excess grease away.
Greensmaster 3200/3200–D Product Records and Maintenance
Page 2 – 5
Figure 4
Figure 5