Toro Greensmaster 3200 Service Manual page 69

15. Disconnect electrical connections from the follow-
ing engine components (Fig. 28):
A. The black (negative) battery cable (37) and
Black wire harness ground (38) on the lower engine
block.
B. The red (positive) battery cable (39) and red
wires and connector on the starter solenoid.
C. The orange wire and connector on the glow plug
bus.
D. The blue and blue/white wires and connector on
the ETR solenoid.
E. The blue wire on the water temperature switch.
F. The green/blue wire on the oil pressure switch.
G. The blue and white wires and connector to the
alternator.
16. Remove both whiz screws (44) securing the dust
shield (43) to the front engine mount (13) (Fig. 28).
17. Remove alternator (52), water pump pulley (53), fan
adapter (2), and crank shaft pulley (54) from the engine
for better clearance (Fig. 28).
Greensmaster 3200–D
18. Remove three whiz nuts (20), plate washers (21),
and cap screws (19) securing the front engine mount
(13) and rear engine mount (11) to the rubber mounts
(18) (Fig. 28).
One person should operate the chain fall
or hoist while the other person guides the
engine out of the frame.
19. Remove engine from the frame.
A. Attach a short section of chain between both lift
tabs located at each end of the cylinder head.
B. Connect a hoist or chain fall at the center of the
short section of chain.
IMPORTANT: Make sure not to damage the engine,
fuel and hydraulic lines, electrical harness, or other
parts while removing the engine.
C. Slowly remove the engine and mounts from the
machine.
20. Remove engine mounts, backing plate, and pump
plate as necessary to repair the engine.
Page 4 – 27
CAUTION
Perkins Diesel Engine