Bedbar Removal And Installation (4-Bolt Adjust Cutting Units) - Toro Greensmaster 3200 Service Manual

Bedbar Removal and Installation (4–Bolt Adjust Cutting Units)
Removal
1. Position cutting unit on a clean level surface to allow
access to the bedbar and rear roller.
2. Remove rear roller (see Rear Roller Removal and
Installation).
Note: The top hex head screws should remain in the
adjustment brackets. This will allow for an easier adjust-
ment of the bedbar when it is reinstalled (Fig. 34).
3. Remove bottom hex head screw from each bedbar
adjustment bracket located on both sides of the frame
(Fig. 34).
4. Remove both wheel bolts (6) from each end of the
bedbar (2) and frame (Fig. 33).
5. Remove bedbar (2) from the cutting unit (Fig.
NO TAG).
Installation
1. Apply antiseize lubricant to the threads of both
wheel bolts (6) (Fig. 33).
2. Position bedbar (2) to the cutting unit. Insert wheel
bolts (6) through the frame and screw into the bedbar
(Fig. 33).
3. Torque both wheel bolts (6) from 20 to 40 ft–lbs ( 2.8
to 5.5 kg–cm).
4. Start bottom hex head screws into the bottom of the
adjustment brackets. Keep bedknife away from the reel
while running up both screws to contact the bedbar ears
(Fig. 34).
5. Reinstall rear roller (see Rear Roller Removal and
Installation).
6. Adjust bedbar to reel (see Bedknife to Reel Adjust-
ment).
Greensmaster 3200/3200–D
1
2
1. Top hex head screw
2. Adjustment bracket
Page 8 – 29
3
Figure 34
3. Bottom hex head screw
Cutting Units