Leveling Front Roller To Reel Adjustment - Toro Greensmaster 3200 Service Manual

Leveling Front Roller to Reel Adjustment

1. If the cutting unit is not removed from the machine,
A. Park machine on a clean and level surface, low-
er cutting units, stop engine, engage parking brake,
and remove key from the ignition switch.
B. Remove reel motor from the cutting unit and cut-
ting unit from lift arm (see Cutting Unit Removal and
Installation).
Note: Make sure leveling plate covers the full length
of reel blades. Three blades must contact the plate.
2. Position cutting unit on a cutting leveling plate or a
known flat and level surface.
3. Position a 1/4–inch or thicker bar stock under the
reel blades and against the front face of the bedknife.
Note: Make sure both front brackets are in the same
hole (see Attitude Adjustment).
4. Loosen both lock nuts securing the right front brack-
et.
Note: The right front bracket is secured to the frame
with an eccentric bolt, while the left front bracket is se-
cured with a shoulder bolt. The eccentric bolt has an off-
set, which when rotated, acts as an eccentric (cam) to
raise or lower the roller. On the bolt head there is an
identification dot which denotes the offset of the bolt.
The dot indicates in which direction the right end of roller
moves when bolt is turned.
5. While holding the reel securely on the plate and
maintaining pressure on the front roller, rotate eccentric
bolt until the roller is level.
Note: If additional adjustment is required, replace
shoulder bolt on the left front bracket with another ec-
centric bolt, part no. 95–1617.
6. Verify roller is level. Insert a piece of paper or 0.003
inch (0.076 mm) feeler gauge under each end of the roll-
er.
7. When the roller is level, tighten lock nuts securely.
Greensmaster 3200/3200–D
1
2
1. Lock nuts
2. Right front roller bracket
Page 8 – 13
3
Figure 15
3. Eccentric bolt
Cutting Units