Toro Greensmaster 3200 Service Manual page 67

10. Remove muffler as follows (Fig. 34):
A. Remove four cap screws and flat washers se-
curing the exhaust plate to the engine exhaust man-
ifold.
B. Remove muffler shield from the muffler and
pump plate by removing four cap screws.
C. Remove two cap screws securing the muffler to
the pump plate.
CAUTION
The muffler and muffler tube may be hot.
To avoid possible burns, allow the ex-
haust system to cool before working on
the muffler and muffler tube.
11. Remove radiator as follows (Fig. 26):
A. Remove alternator guard (29) from radiator sup-
port (8) and frame bracket.
B. Remove cable tie (37) from the breather hose
(24). Disconnect breather hose and radiator hose
(17) from the radiator elbow (26).
C. Disconnect radiator hose (2) from the bottom of
the water pump.
D. Disconnect hose (34) from air cleaner at the ra-
diator support (8). Remove hose from the machine
E. Remove screen (10) from the radiator support.
F. Remove cap screws (7) from radiator support
and frame. Remove cap screw (18), flat washer (36)
and lock nut (9) securing the radiator support to the
frame tab.
G. Make sure cable ties and clamps securing hoses
to the frame and supports are removed.
H. Pull radiator and hoses from the machine.
12. Loosen cap screw (22) and lock nut (23) securing
the throttle tab (33) and throttle control cable (40) to the
front engine mount (13). Disconnect the cable from the
governor lever (51) (Fig. 28).
Greensmaster 3200–D
4
7
1. Cap screw
2. Lock washer
3. Exhaust plate
4. Muffler shield
Page 4 – 25
7
5
6
Figure 34
5. Muffler
6. Pump plate
7. Cap screw
Perkins Diesel Engine
3
1
2
7