Toro Greensmaster 3200 Service Manual page 231

Installation (Fig. 4)
1. Secure wheel (24) to the four drive studs of the hy-
draulic motor and hub assembly (2) with four lug nuts
(23). Torque nuts from 45 to 55 ft–lb, (6.2 to 7.6 kg–m).
2. Reinstall grease fitting into hydraulic motor and hub
assembly (2) so it points away from the wheel (24).
3. Install flangette (7), bearing (5), and relube flangette
(6) onto the motor shaft.
4. Position hydraulic motor and hub assembly (2), flan-
gettes (6 and 7) with bearing (5), and wheel (24) into the
castor fork (1). Make sure hose fittings on the motor face
the rear.
Greensmaster 3200/3200–D
5. Secure hydraulic motor and hub assembly (2)
loosely to the left inside of the castor fork (1) with both
socket head screws (11) lock nuts (12).
6. Secure flangettes (6 and 7) with bearing (5) loosely
to the right inside of the castor fork (1).
A. Position grease fitting (21) facing downward.
B. Torque both socket head screws (11) to 85 ft–lb
(11.8 kg–m).
C. Torque both hex head screws (9) to 30 ft–lb (4.2
kg–m).
7. Apply loctite to both set screws (22). torque both
screws from 80 to 100 in–lb (92 to 115 kg–cm).
Page 7 – 9
Wheels and Brakes