Toro Greensmaster 3200 Service Manual page 228

D. Place second bearing cone on the castor fork
shaft with the wide edge up. Place remaining steer-
ing washer on top of the bearing cone.
E. Run hex nut (1) onto castor fork shaft until drag is
felt while rotating the castor fork. Back–off hex nut to
align the hole to the slot. Install and secure cotter pin
(2) into the shaft.
F. Secure ball joint (10) to the castor fork (4) with
both jam nuts (17).
G. Secure fuel tank base plate to the frame with
three hex head screws and flat washers. The two
screws and flat washers go on the top of the plate at
the front corners of the tank. The third screw goes
through support from under the plate.
Wheels and Brakes
3. Install wheel and hub assemblies into the castor fork
(4). Insert bolt (5) into one of the castor fork mounting
holes. Install a spacer (20), and slide bolt through the
wheel and hub assemblies.
4. Install another spacer (20) onto the bolt (5). Route
the bolt through the remaining castor fork (4) mounting
hole.
5. Position bend of the bolt (5) head under the bottom
edge of the castor fork (4). Install and tighten locknut (9)
to secure wheel to the castor fork. Do not overtighten
locknut, the wheel must rotate freely.
6. Wipe grease fitting clean on hub (6) and pivot hous-
ing. Pump grease into hub until grease is seen exiting at
both shaft seals (24). Pump grease into pivot housing
until grease is seen exiting at both ends of the housing.
Wipe up excess grease.
Page 7 – 6
Greensmaster 3200/3200–D