Adding Fuel; Performing Daily Maintenance; Checking The Interlock Switches - Toro Reelmaster 5010-H Operator's Manual

Adding Fuel

1. Park the machine on a level surface, lower the
cutting units, shut off the engine, and remove
the key.
2. Using a clean rag, clean the area around the
fuel-tank cap.
3. Remove the cap from the fuel tank
Figure 49
1. Fuel-tank cap
4. Fill the tank until the level is to the bottom of the
filler neck with diesel fuel.
5. Install fuel-tank cap tightly after filling tank.
Note:
If possible, fill the fuel tank after each use.
This minimizes possible buildup of condensation
inside the fuel tank.
Performing Daily
Maintenance
Service Interval: Before each use or daily
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
Maintenance (page 32).
Checking the Interlock
Switches
Service Interval: Before each use or daily
CAUTION
If safety interlock switches are disconnected
or damaged, the machine could operate
unexpectedly, causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Important:
interlock switch checks, contact your authorized
Toro distributor.
Preparing the Machine
1.
2.
(Figure 49).
Checking the Traction Pedal
Start-Interlock
1.
2.
3.
4.
5.
g021210
Checking the PTO-Start Interlock
1.
2.
3.
Checking the PTO-Run Interlock
1.
2.
3.
4.
Performing Daily
5.
Checking the Parking Brake and
Traction Pedal Run-Interlock
1.
2.
3.
4.
5.
6.
32
If your machine fails any of the
Drive the machine slowly to an open area.
Lower the cutting units, shut off the engine, and
engage the parking brake.
Sit in the operator's seat.
Engage the parking brake.
Press the PTO switch to the D
Press the traction pedal.
Rotate the key to the S
Note:
The starter should not crank the engine
with the traction pedal pressed.
Sit in the operator's seat.
Press the PTO switch to the E
Start the engine.
Note:
The engine should not start with the PTO
switch in the E position.
NGAGE
Sit in the operator's seat.
Press the PTO switch to the D
Start the engine.
Rise from the seat.
Press the PTO switch to the E
Note:
The PTO should not run when you are
out of the operator's seat.
Sit in the operator's seat.
Engage the parking brake.
Press the PTO switch to the D
Keep your foot off the traction pedal.
Start the engine.
Press the traction pedal.
Note:
The engine should shut off when the
parking brake is engaged and the traction pedal
is pressed.
position.
ISENGAGE
position.
TART
position.
NGAGE
position.
ISENGAGE
position.
NGAGE
position.
ISENGAGE