Drive System Maintenance; Checking The Tire Air Pressure; Checking The Torque Of The Wheel Nuts; Adjusting The Traction Drive For Neutral - Toro Reelmaster 5010-H Operator's Manual

Figure 105
1. Cap
2. Fuse
4. Remove the fuse from the fuse holder.
5. Insert a fuse of the same type and amperage.
6. Assemble the cap onto the in-line fuse holder.
7. Lower and latch the seat; refer to
Seat (page 44).
g378242
3. Fuse holder (labeled 10 A
F T P )
USE ELEMATIC WR
Lowering the
Drive System
Maintenance
Checking the Tire Air
Pressure
Service Interval: Before each use or daily
Important:
Maintain the recommended pressure
in all tires to ensure a good quality of cut and
proper machine performance. Do not underinflate
the tires.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Measure the tire air pressure.
Note:
The correct air pressure in the tires is 83
to 103 kPa (12 to 15 psi).
3. If needed add air to or remove air from the tire.
4. Repeat steps
Checking the Torque of the
Wheel Nuts
Service Interval: After the first hour
After the first 10 hours
Every 250 hours
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Maintain the proper torque on the wheel nuts.
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Torque the wheel nuts to 94 to 122 N∙m (70 to
90 ft-lb).
Adjusting the Traction
Drive for Neutral
Important:
The machine must not move when
the traction pedal is released (in the N
position). If the machine moves, adjust traction
pump as follows:
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Jack up the front of the machine until the both
front tires are off the ground, and support the
machine with jack stands, refer to
61
43).
2 and 3 at the other tires.
43).
EUTRAL
43).
Specifications