Toro Reelmaster 5010-H Operator's Manual page 27

InfoCenter Icon Description (cont'd.)
Battery
Motor/Generator (not charging)
Motor/Generator (charging)
E-Reel
Front Backlap
Rear Backlap
The cutting units are lowering.
The cutting units are raising.
PIN passcode
CAN bus
InfoCenter
Bad or failed
Bulb
Output of TEC controller or control
wire in harness
Switch
Release the switch.
Change to the indicated state.
Symbols are often
combined to form
sentences. Some
examples are shown
below
Put the machine into Neutral.
Engine start is denied.
Engine shutdown
Engine coolant is too hot.
Sit down or set parking brake
Using the Menus
To access the InfoCenter menu system, press the
menu access button while at the main screen. This
brings you to the main menu. Refer to the following
tables for a synopsis of the options available from
the menus:
Main Menu
Menu Item
Faults
Service
Diagnostics
Settings
About
Service
Menu Item
Hours
Counts
Diagnostics
Menu Item
Cutting Units
Hi/Low Range
PTO
27
Description
The Faults menu contains a list
of the recent machine faults.
Refer to the Service Manual or
contact your Toro Distributor
for more information on
the Faults menu and the
information contained there.
The Service menu contains
information on the machine
such as hours of use, counters,
and other similar numbers.
The Diagnostics menu
displays the state of each
machine switch, sensor, and
control output. You can use
this to troubleshoot certain
issues as it quickly tells you
which machine controls are on
and which are off.
The Settings menu allows
you to customize and modify
configuration variables on the
InfoCenter display.
The About menu lists the
model number, serial number,
and software version of your
machine.
Description
Lists the total number of hours
that the machine, engine and
PTO have been on, as well
as the number of hours the
machine has been transported
and service due.
Lists numerous counts the
machine has experienced.
Description
Indicates the inputs, qualifiers,
and outputs for raising and
lowering the cutting units.
Indicates the inputs, qualifiers,
and outputs for driving in
transport mode.
Indicates the inputs, qualifiers,
and outputs for enabling the
PTO circuit.