Toro Reelmaster 5010-H Operator's Manual page 28

Engine Run
Backlap
Settings
Menu Item
Units
Language
LCD Backlight
LCD Contrast
Front Backlap Reel Speed
Rear Backlap Reel Speed
Protected Menus
Auto Idle
Blade Count
Mow Speed
Height of cut (HOC)
F Reel RPM
R Reel RPM
Economy Mode
*Only "operator-faced" text is translated. Faults,
Service, and Diagnostics screens are "service-faced."
Titles are in the selected language, but menu items
are in English.
Indicates the inputs, qualifiers,
and outputs for starting the
engine.
Indicates the inputs, qualifiers
and outputs for operating the
backlap function.
Description
Controls the units used on the
InfoCenter. The menu choices
are English or Metric.
Controls the language used
on the InfoCenter*.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Controls the speed of the front
reels in backlap mode.
Controls the speed of the rear
reels in backlap mode.
Allows the
superintendent/mechanic
to access protected menus by
inputting a passcode.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary.
Controls the number of blades
on the reel for reel speed.
Controls the ground speed for
determining the reel speed.
Controls the height of cut
(HOC) for determining the reel
speed.
Displays the calculated reel
speed position for the front
reels. The reels can also be
manually adjusted.
Displays the calculated reel
speed position for the rear
reels. The reels can also be
manually adjusted.
When activated, the Economy
Mode lowers the engine
speed while mowing to reduce
noise and fuel consumption.
The reel speed does not
change, but the mow speed is
decreased if the mow stop is
not adjusted accordingly.
About
Menu Item
Model
SN
Machine Controller Revision
CU 1
CU 2
CU 3
CU 4
CU 5
Generator
InfoCenter Revision
CAN Bus
Protected Menus
There are 2 additional display screens and 7 operating
configuration settings that are adjustable within the
Settings Menu of the InfoCenter: Auto Idle, Blade
Count, Mow Speed, Height of Cut (HOC), F Reel
RPM, R Reel RPM, and Economy Mode. These
settings can be locked by using the Protected Menu.
Note:
At the time of delivery, the initial password
code is programmed by your distributor.
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M
AIN
scroll down to the S
right button (Figure
28
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
each cutting unit.
Lists the software revision of
the motor/generator.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
M , use the center button to
ENU
M and press the
ETTINGS ENU
47).
Figure 47
g028523