Huawei USG6000E Series Hardware Manual page 506

Hide thumbs Also See for USG6000E Series:

Table of Contents

HUAWEI USG6000E Series

Hardware Guide

There are four types of optical fibers for the USG6000E: LC/PC-LC/PC, LC/PC-

SC/PC, LC/PC-FC/PC, and MPO/PC-MPO/PC, which are based on the types of

connectors on both ends of the fibers, as listed in

Table 4-309 Common optical fiber types

Issue 08 (2022-04-20)

optical interface. Then insert the fiber into the optical interface, rotate

the outer screw jacket clockwise, and then fasten the optical connector.

To remove an optical fiber, rotate the outer screw jacket counter-

clockwise on the optical interface until the screw loosens. Then gently

pull out the optical fiber.

MPO/PC optical fiber connector

Note the following points when removing and inserting an MPO/PC fiber

When inserting the connector, hold the shell labeled "PUSH" and feed the

male connector into the female connector until you hear a clicking sound.

The male and female connectors are securely installed.

To disassemble the connector, hold the shell labeled "PULL" and remove

the male connector.

Transmission

Single-mode/

On the USG6000E

4 Hardware Overview

On the peer device

Show Quick Links

Table of Contents