Huawei USG6000E Series Hardware Manual page 532

HUAWEI USG6000E Series
Hardware Guide
● Make sure that the PC and the USG are connected to the same ground point.
● Pay attention to port numbering and make sure that the cable is connected to
Tools
Console cable (prepared by the user)
Procedure
Step 1 Before connecting a console cable, attach temporary labels to both ends of the
cable for identification.
Step 2 Connect the RJ45 connector of the console cable to the console port (RJ45) of the
USG.
Step 3 Connect the DB9 connector of the console cable to the COM port of the
management PC.
Figure 5-14 Connecting a console cable to the USG
Step 4 Remove the temporary labels and attach labels 2 cm away from connectors at
both ends of the console cable.
----End
Issue 08 (2022-04-20)
Before cable connection, labels must be prepared for the cable.
NO TICE
Otherwise, the console port of the USG may be damaged.
the correct port, preventing damage to ports or the device.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Installation
525