Huawei USG6000E Series Hardware Manual page 537

HUAWEI USG6000E Series
Hardware Guide
●
5.3.7 Connecting a Power Adapter
A power adapter can be used to supply power for a USG6510E, USG6510E-POE,
USG6530E. Prepare an AC power cable to connect the power connector and the
power source of the equipment room.
Context
Before connecting a power connector, ensure that the power source of the
equipment room meets the input requirements of the USG power module.
Procedure
Step 1 Ensure that the PGND cable is properly grounded.
Step 2 Insert a cable-retention clip into the jack next to the power socket.
Step 3 Connect a power adapter.
1.
2.
3.
4.
Issue 08 (2022-04-20)
The optical module is damaged or the optical fiber is broken. Replace the
optical module or the optical fiber.
Plug the C7 plug of the AC power cable into the C14 socket of the power
adapter.
Insert the tuning fork plug connector of the power adapter into the power
socket on the USG rear panel and adjust the cable-retention clip to an
appropriate position.
Use a cable-retention clip to bundle the cable of the power adapter and
adjust the cable-retention clip to fasten the cable.
Plug the other end of the AC power cable to the AC power socket or the
output of the AC power supply device.
NO TE
The USG does not have any power switch. The power supply switch determines the
power-on and power-off of the USG.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Installation
530