Huawei USG6000E Series Hardware Manual page 531

HUAWEI USG6000E Series
Hardware Guide
Figure 5-13 Installing the micro SD card and anti-theft board
----End
Follow-up Procedure
After the micro SD card is installed, power on the USG and run the display sd-
card information command in any view to check the micro SD card installation
and file system mounting status. If SD Card Physical State is Present and SD
Card File System State is Mounted, the micro SD card is working properly.
●
●
5.3.4 Connecting a Console Cable
After connecting a PC to the console port of a USG6510E, USG6510E-POE,
USG6530E with a console cable, you can use the terminal emulation program on
the PC to access the command configuration interface of the USG6510E,
USG6510E-POE, USG6530E.
Precautions
Before connecting a console cable, perform the following operations:
●
●
Issue 08 (2022-04-20)
If SD Card Physical State is Absent, re-install the micro SD card and try
again. If SD Card Physical State remains the same, the USG may fail to
identify the micro SD card. You are advised to use another micro SD card.
If SD Card File System State is Unmounted, the micro SD card format might
not be ext4. You need to run the reset sd-card command in the system view
to format the micro SD card.
Check preparations.
A PC is ready, a USG has been installed, and the ports to be connected are
planned.
Prepare cable labels.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Installation
524