Huawei USG6000E Series Hardware Manual page 559

HUAWEI USG6000E Series
Hardware Guide
Figure 5-31 Connecting an Ethernet cable
Step 3 Lay out the Ethernet cable along a cabinet and route the cable through the cable
hole for the signal cables at the top (overhead cabling) or bottom (underfloor
cabling) of the cabinet.
Step 4 Remove the temporary labels and attach labels (2 cm away from the connectors)
at both ends of the Ethernet cable.
----End
Follow-up Procedure
Verify the following after the installation:
●
●
5.4.6 Installing Optical Transceivers and Connecting Optical
Fibers
This section describes how to install optical transceivers on the GE , 10GE, or 40GE
optical ports of the USG and connect them to the ports of the peer device using
optical fibers according to the network plan.
Context
The USG supports both 1 Gbit/s , 10 Gbit/s, and 40 Gbit/s optical modules. The
optical modules at both ends are the same, including the optical fiber type
(single-mode or multi-mode), optical fiber connector type (LC/PC, SC/PC, FC/PC,
or MPO/PC-MPO/PC), and transmission rate. If different optical modules are used
at the two ends, the communication may fail.
Issue 08 (2022-04-20)
The labels at both ends of the cable are correct, clear, neat, and facing the
same direction.
The cables and connectors are free of any damage or breakage and are
connected properly and reliably.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Installation
552