Huawei USG6000E Series Hardware Manual page 585

HUAWEI USG6000E Series
Hardware Guide
Context
Before you power on the USG, ensure that:
●
●
Procedure
●
●
Issue 08 (2022-04-20)
The power cable and PGND cable are properly connected.
The power switch in the equipment room is easy to locate so that you can
power off devices in the case of accidents.
Power on the USG.
Turn on the switch of the power supply device. The USG starts.
You can identify the USG status based on indicators on the front and rear
panels. Indicators shown in
normally.
Figure 5-51 Indicators when the USG runs normally
Power off the USG.
NO TICE
Before powering off the USG, ensure that configuration data is saved.
Otherwise, the configuration data may be lost.
If the USG will be administratively shut down for a long time, turn off the
power switch. After powering off the USG, set it aside properly according to
storage requirements.
Copyright © Huawei Technologies Co., Ltd.
USGFigure 5-51 indicate that the USG runs
5 Hardware Installation
578