Siemens SICHARGE UC Operating Instructions Manual page 55

Connecting the PE conductor
First, connect the PE conductor of the power supply cable to the grounding connector:
1. Remove the sheath of the power supply cable to approximately 8 cm in length.
2. Select a wire end ferrule for the appropriate conductor cross section.
3. Strip the insulation from the end of the conductor so that the remaining insulation extends up to the ferrule.
4. Properly attach the wire end ferrule to the conductor end.
5. Insert the wire end ferrule into the terminal strip of the ground connection.
6. Check the connection of the PE conductor to the PE terminal.
Connecting cable L1, N
To connect a conductor, follow these steps:
1. Remove the sheath of the power supply cable to a length of approximately 5 cm.
2. Select a wire end ferrule for the appropriate conductor cross section.
3. Strip the insulation from the end of the conductor so that the remaining insulation extends up to the ferrule.
4. Properly attach the wire end ferrule to the conductor end.
5. Insert the wire end ferrule into the terminal strip of the respective conductor.
6. Check the connection of the conductor to the terminal.
Attaching the power supply cable
Secure the power supply cable after the connection to the cable duct.
Connection of additional SICHARGE UC dispensers
The main connection is looped through to connect additional SICHARGE UC dispensers to the same SICHARGE UC
charging station. This is shown as item f in the "Power supply cable connection" figure. To do this, follow the above
sequence to connect the power supply cable.
Operating Instructions | SICHARGE UC Dispenser UL
55