Commissioning; Switching On The Dispenser - Siemens SICHARGE UC Operating Instructions Manual

SICHARGE UC Dispenser UL | Operating Instructions
SECTION 7

Commissioning

7.1

Switching on the dispenser

To commission the SICHARGE UC dispenser, switch on the power supply of the SICHARGE UC charging station.
WARNING
Qualified personnel
Only a qualified and trained electrician may work on the SICHARGE UC dispenser.
DANGER
Risk of electric shock when moist due to condensed water
Before commissioning the SICHARGE UC dispenser, an authorized and qualified electrician must check
whether there is moisture inside the SICHARGE UC dispenser. Manually remove even small amounts of
condensation before commissioning. Take appropriate measures for drying.
Do not switch off the power supply for an extended period of time after commissioning. This will prevent
condensation in the SICHARGE UC dispenser.
WARNING
Injuries or damages
When the charging plug is not plugged into the plug holder before commissioning, it can cause injuries or
damages when the device is switched on.
• Before you switch on the SICHARGE UC dispenser, make sure that the charging plug is in the plug holder.
• Leave the charging plug in the plug holder during the entire switch-on operation.
Note
Location of the SICHARGE UC charging station with EMERGENCY OFF button
On the outside of the SICHARGE UC dispenser, attach a visible map with the location of the
SICHARGE UC dispenser and the connected SICHARGE UC charging station.
60