Positioning Control Program Examples - Mitsubishi Electric MELSECQ Series User Manual

7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL

7.4 Positioning control program examples

7 - 8
Downloaded from ManualsNet.com
An example of the "Axis 1" positioning control program is given in this section.
[No.1] to [No.3] parameter and data setting program
When setting the parameters or data with the sequence program, set them in the QD70 using the
TO command from the programmable controller CPU. (Carry out the settings while the
programmable controller READY signal [Y0] is OFF.)
When setting the parameters or data with the GX Configurator-PT, the [No.1] to [No.3]
program is not necessary.
No.1 Parameter setting program
No.2 OPR data setting program
search engine
MELSEC-Q
7 - 8