SECTION 1 PRODUCT SPECIFICATIONS
Section 1 is configured for the following purposes (1) to (4).
(1) To understand the outline of positioning control, and the QD70 specifications
(2) To carry out actual work such as installation and wiring
(3) To set parameters and data required for positioning control
(4) To create a sequence program required for positioning control
Read "Section 2" for details on each control.
CHAPTER 1 PRODUCT OUTLINE ................................................................................. 1- 1 to 1- 14
CHAPTER 2 SYSTEM CONFIGURATION ..................................................................... 2- 1 to 2- 9
CHAPTER 3 SPECIFICATIONS AND FUNCTIONS ...................................................... 3- 1 to 3- 13
CHAPTER 4 DATA USED FOR POSITIONING CONTROL.......................................... 4- 1 to 4- 31
CHAPTER 5 SETUP AND PROCEDURES BEFORE OPERATION............................. 5- 1 to 5- 20
CHAPTER 6 UTILITY PACKAGE.................................................................................... 6- 1 to 6- 19
CHAPTER 7 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL .......... 7- 1 to 7- 20
Downloaded from
ManualsNet.com
AND HANDLING
and functions
search engine