Sharp AR-FX7 Service Manual page 24

66-11
Purpose Operation test/check
Function Used to send 300bps signals. (Signal send level:
(Purpose) Max.)
Section FAX
Item Operation
Operation/procedure
Select the signal number with the 10-key, and press the [START] key.
By setting the signal number, the specified signal is delivered to the
line at the speed of 300bps. (The signal is continuously sent until the
interruption command is provided by pressing the [CUSTOM SET-
TINGS] key.)
The signal send level can be selected from 0dB or the soft SW set
value.
The signal send level is returned to the soft SW set value before exe-
cution of the mode after completion of the mode.
By entering the number and pressing the [START] key during execu-
tion, the signal kind can be changed.
Item
1 NO SIGNAL
2 11111
3 11110
4 00000
5 010101
6 00001
Note: Executable only when the FAX is installed.
66-12
Purpose Operation test/check
Function Used to send 300bps signals. (Signal send level: Set
(Purpose) by soft SW)
Section FAX
Item Operation
Operation/procedure
Select the signal number with the 10-key, and press the [START] key.
By setting the signal number, the specified signal is delivered to the
line at the speed of 300bps. (The signal is continuously sent until the
interruption command is provided by pressing the [CUSTOM SET-
TINGS] key.)
The signal send level can be selected from 0dB or the soft SW set
value.
The signal send level is returned to the soft SW set value before exe-
cution of the mode after completion of the mode.
By entering the number and pressing the [START] key during execu-
tion, the signal kind can be changed.
Item
1 NO SIGNAL
2 11111
3 11110
4 00000
5 010101
6 00001
Note: Executable only when the FAX is installed.
66-13
Purpose
Function (Purpose)
Section
Item
Operation/procedure
Enter the number with the 10-key, [*] key, and [#] key.
Press the [CLEAR] key to return to the initial state.
Press the [START] key to register the entered number.
Note: Executable only when the FAX is installed.
66-14
Purpose
1
Function
(Purpose)
Section
Item
Operation/Procedure
1. Select the item with the 10-key, and press the [START] key.
2. Set the make time with the 10-key.
The dial is sent with the set value + 26ms.
The sending dial cannot be interrupted.
0 EXECUTE
1 MAKE TIME
Note: Executable only when the FAX is installed.
66-15
Purpose
Function
(Purpose)
Section
Item
Operation/Procedure
1. Select the item with the 10-key, and press the [START] key.
2. Set the make time with the 10-key.
The dial is sent with the set value + 26ms.
The sending dial cannot be interrupted.
0 EXECUTE
1 MAKE TIME
Note: Executable only when the FAX is installed.
AR-FX7 SIMULATION 6 - 9
Setting
Used to register the dial numbers.
FAX
Operation
Operation check/test
Used to perform the dial test. (10 PPS send test)
FAX
Operation
Item Content
Execution
Dial pulse make time setting
Operation check/test
Used to perform the dial test. (20 PPS send test)
FAX
Operation
Item Content
Execution
Dial pulse make time setting
1
Setting range
–
0-15
1
Setting range
–
0-15