Advertisement
Display overview
1
2
12345 H
6
1. Top bar
2. Operation mode tab
3. Status bar
4. Quick action bar
5. Bottom bar
6. Product view
Fuses
The location of the fuses is in the fuse holder, behind the
cover of the electrical enclosure. A blown fuse is
identified by a burned connector. For information about
low voltage (24 DC), refer to
90 .
The connection to the mains socket has high voltage
(400/460 VAC). For information about the correct fuses
for the product, refer to
mains socket on page 113 . The product has SoftStart
and can be started with most types of fuses.
If the fuse blows again a short period after you replaced
it, there is a short circuit. Let an approved servicing
agent repair the product before you operate the product
again. The fault can be in the electrical system or in the
product that it is connected to.
Symbols on the product
WARNING: This product can be
dangerous and cause serious injury or
death to the operator or others. Be careful
and use the product correctly.
Read the manual carefully and make sure
that you understand the instructions
before you use the product.
Use heavy duty clothing that is not loose
but lets you move freely.
1401 - 002 - 15.10.2021
3
4
XX BAR
5
Fuse overview on page
Guide values for connection to a
Use protective gloves.
Use boots with steel toe-caps and non-slip
soles.
Use respiratory protection in location
where the air can be harmful to your
health. Use a protective helmet, hearing
protection and eye protection. Refer to
Personal protective equipment on page
20 .
High voltage.
Risk of injury. Make sure that no material
can fall down and cause damage when
you operate the product.
Risk of injury. Material can fall during
operation. Use personal protective
equipment and keep distance to the
product during operation.
Risk of injury. Make sure that you are
above the product when you operate on a
slope. There is a risk that the product falls.
Always be careful when you operate near
edges. Make sure that the product is
stable and does not move to the edge
during operation. Make sure that the
surface has satisfactory bearing capacity.
Do the inspection and/or maintenance
with the motor stopped and the power
plug disconnected.
Always connect the product through an
RCD with personal protection. The RCD
must trip at a ground fault of 30 mA.
Make sure that the power cord is behind
the product when you move the product.
Also make sure that the power cord is
behind the product when the outriggers
are retracted or extended. There is a risk
11
Advertisement
