Advertisement
cooling kit (DXR 275, DXR 305, DXR 315) on page 108 .
The heat protection kit includes heat-resistant outrigger
feet (A), caterpillar tracks (B) and breaker (C). The heat
protection kit also includes heat-resistant hose (D).
The air flow to the installed tool on the product can be
adjusted with an adjustable valve (E) on arm 1. If
possible, keep the airflow high. If the airflow blows too
much dust at the tool, lower the airflow.
B
Remote control
The product is operated with a remote control.
The remote control can operate by radio signal
transmission. If there is an interference in the
transmission, the frequency changes automatically. A
pairing operation between the product and the remote
control is done by the factory. A new pairing operation is
necessary if the remote control is replaced or if you
change remote controls between products. Refer to
do a pairing operation between the remote control and
the product (DXR 145) on page 56 and To do a pairing
operation between the remote control and the product
(DXR 275, DXR 305, DXR 315) on page 57 .
The remote control can also operate with a CAN bus
cable connected between the remote control and the
product. The CAN bus cable can for example be used
when the state of charge in the remote control batteries
is low. For instructions on how to connect the remote
control to the product with a cable, refer to
the remote control to the product with a CAN bus cable
(DXR 145) on page 59 and To connect the remote
control to the product with a CAN bus cable (DXR 275,
DXR 305, DXR 315) on page 59 .
The remote control has all controls that are necessary to
operate the product. The remote control has a digital
display with a menu system. Refer to
page 36 .
Home view
The display has 2 home views. There is 1 home view for
when the motor is off. Refer to
1401 - 002 - 15.10.2021
E
D
A
C
To connect
Menu system on
To start the remote
control on page 54 . The other home view is for when
the motor is on. Refer to
on page 52 and To start the product (DXR 275, DXR
305, DXR 315) on page 53 .
The symbols in the quick action bar changes if the motor
is off or on.
Home view, motor off
Position
Description
1
Quick action to select the pattern test
mode. Refer to
page 49 .
Home view, motor on
To
Position
Description
1
Quick action to select the tool in operation.
2
Quick action to see the product status.
3
Quick action to set the water and the
grease level.
4
Quick action to change language or to see
the faults. The symbol will change if the
product finds a warning or an error.
To start the product (DXR 145)
1
12345 H
XX BAR
"Pattern test mode" on
1
12345 H
XX BAR
4
2
3
35
Advertisement
