Advertisement
8. Put a magnet on the bottom side of the radio
communication receiver on the magnet symbol (D) in
5s after the start of the product. The indicator (E) on
the radio communication receiver flashes orange
quickly when it waits for a pairing operation to start.
D
E
Note:
It is necessary to put the magnet on the
magnet symbol in 5s after the start of the product.
After 5s the radio communication receiver cannot do
the pairing operation.
9. Remove the magnet.
10. A serial number shows on the information center
display when a radio communication receiver is
found.
11. Make sure that the serial number on the information
display agrees with the serial number on the radio
communicator receiver.
12. If the serial numbers do not agree, the pairing
operation was not done correctly. Do the procedure
that follows.
a) Find the product with the agreed serial number
and turn that product off.
b) Stop your product. Refer to
(DXR 145) on page 62 .
c) Do the pairing operation again.
13. Push the right side button when the serial numbers
agree. A message on the information center display
will show for 2 seconds that the pairing operation is
done.
14. Stop the product to restart the radio communication
receiver. Refer to
To stop the product (DXR 145) on
page 62 .
1401 - 002 - 15.10.2021
To stop the product
15. Restart the remote control. Refer to
remote control on page 54 .
16. Start the product. Refer to
145) on page 52 .
17. Make sure that there is a radio signal symbol in the
information center display. Refer to
center display on page 51 .
18. Install the right side cover on the product.
To do a pairing operation between the
remote control and the product (DXR
275, DXR 305, DXR 315)
The pairing operation between the product and the
remote control is done by the factory. A new pairing
operation is necessary if the remote control is replaced
or if you change remote controls between products.
1. Start the remote control. Refer to
control on page 54 .
2. Push the left side button (A) and the right side button
(B) at the same time.
C
Information center
A
Note:
The Information center display change
mode if the buttons are pushed at the same time.
3. Push the left side button (A) to go to selection "2" in
the information center display.
4. Push the right side button (B) to select selection "2".
The symbol (C) shows in the information center
display.
5. Push the left and right side button at the same time
and hold for 3 seconds.
To start the
To start the product (DXR
Information
To start the remote
B
57
Advertisement
