Advertisement
To calibrate the hydraulics with "Auto (calibrate)"
During calibration of the valves, the product can make
small movements.
1. Disconnect the hydraulic hoses from the installed
tool.
Note:
It is not necessary to remove the tool from
the product.
2. Start the product. Refer to
145) on page 52 and To start the product (DXR
275, DXR 305, DXR 315) on page 53 .
3. Extend the outriggers. Refer to
outriggers on page 61 .
4. Press the menu button (A) on the remote control.
12345 H
A
5. Select "Calibrate hydraulics" in the "Controls" menu
on the display.
6. Select "Auto (calibrate)".
7. Select "Pressure and valves" or "Pressure".
50
To start the product (DXR
To operate the
XX BAR
8. Push the left top button (B) on the left joystick.
B
9. Push the right joystick forward (C) until the
calibration is completed.
"Control diagnostics"
In "Control diagnostics" you can do function tests of the
controls on the remote control. Each control is shown in
the display. The control indicators in the display changes
from white to orange when you do the function tests.
Operate a control on the remote control to its maximum.
The control operates correctly when the control indicator
shows 100% in the display.
CONTROL DIAGNOSTICS
O% O%
O% O%
O% O%
O% O%
PRESS AND HOLD BACK TO EXIT
"System" menu
Tools
Machine status
Functions
Controls
System
0%
PRESSURE CALIBRATION
50 bar / 725 PSI
ACTIVATE AND PUSH RIGHT JOYSTICK
FORWARD
C
1
2
3
1
2
1
2
Remote settings
Revisions
Factory settings
1401 - 002 - 15.10.2021
Advertisement
