Communications Using The Engineering Tool - Mitsubishi Electric MELSEC iQ-R Series User Manual

Communications using the engineering tool

This type of communications are used to configure the settings of or monitor each station using the engineering tool.
It allows seamless communications with stations on different types networks.
Ethernet
Engineering tool
Ethernet
Communications can be made with stations up to eight networks apart (number of relay stations: 7).
When the networks consist of only MELSEC iQ-R series
Communication paths are automatically set for communications with the following networks of MELSEC iQ-R series.
• Ethernet
• CC-Link IE TSN
• CC-Link IE Controller Network
• CC-Link IE Field Network
• MELSECNET/H
■Setting method
Check that "Dynamic Routing" in "Application Settings" is set to "Enable".
• Communication paths are automatically set, but they can also be manually set. ( Page 178 When the
networks consist of MELSEC iQ-R series and other series)
• The communication path cannot be set automatically for Ethernet-equipped modules connected via a
router. Set the communication path manually. ( Page 178 When the networks consist of MELSEC iQ-R
series and other series)
(Relay station)
(Relay station)
9 FUNCTIONS
9.3 Transient Transmission
9
177