14.
Click the [Apply] button.
15.
Click the [OK] button to close the connection settings.
16.
Select [Close with Reflecting the Setting] and close the "EtherNet/IP Configuration" window.
17.
Write the set parameters to the originator-side CPU module. Then reset the CPU module or power off and on the system.
[Online] [Write to PLC]
In this example, default values are used for parameters that are not shown above. For the parameters, refer to
the following.
Page 112 EtherNet/IP Parameter Settings
13 PROGRAMMING
338
13.6 Class3 Tag Communications Communication Example