Hitachi GS4000 Series Quick Start Manual page 35

Procedure 2.
Install a memory card.
Insert a memory card into both the memory card slot 0 and the memory card slot 1 of a basic control unit (BCU0). Memory
cards must be installed into both BCU0 and BCU1 in case that a basic control unit is redundant.
Caution While the access indicator of BCU (ACC lamp) is lit, the memory card is being accessed. DO NOT
pull out a memory card or turn off the power switch while the memory card is being accessed. If
so, you could permanently damage the memory card.
NOTE When inserting a memory card, the surface labeled with the part number "HN-F9244-66X" should
be faced up.
NOTE Use a standard type of memory card provided by HITACHI. The operation cannot be guaranteed if
a memory card other than that is used.
When installing a memory card using an option license for GS4000, make sure that the
manufacturing number of a device put on the label of a memory card matches the serial number
of an option license. (You can check these numbers using a packing list provided with GS4000.)
Procedure 3.
Connect a setup terminal to GS4000-160E1
1．
Connect a setup terminal to the CONSOLE port of BCU (BCU0) using a RS－232C cross cable.
2．
Start up a setup terminal.
3． Start up communication software
NOTE GS4000-160E1 is pre-configured in a way that a setup terminal can be connected to a
CONSOLE port of BCU0 when it is shipped from the factory. Connect a setup terminal to a
CONSOLE port of BCU0 in case that a basic control unit is redundant.
NOTE As for the setup of communication software, see the communication software manual.
Procedure 4.
Attach an interface cable.
Attach an interface cable to an interface port.
Procedure 5.
Power on GS4000-160E1.
Set all the switches of GS4000-160E1 to ON.
Caution When powering ON, set all the switches of GS4000 to "ON" within an 8 seconds time period.
Otherwise, the basic control unit (BCU) might detect a conflict between the configuration and the
actual number of active power sources.
Procedure 6.
Check LED.
When BCU0 LED of the front panel of GS4000 is lit in green, it means that GS4000 is started up.
Regarding the process GS4000 goes through until it starts up, see the section "3.2 Other Preparations".
NOTE When the BCU0 LED status is Red (Blinking) or the STATUS CODE display shows numbers 16,
20 or 22, the GS4000 is signaling a problem. Regarding troubleshooting, see Chapter 7:
Troubleshooting.
For other problems which cannot be solved there, see the manuals "GS4000･GS3000 Software
Manual, Operations - Device Management Overview" and "GS4000･GS3000 Software Manual,
Message Log Reference"
QSGGS4KX10-00 5794092-2X
GS4000 Quick Start Guide, Revision 3
17