Hitachi GS4000 Series Quick Start Manual page 52

GS4000 Quick Start Guide, Revision 3
(5) Create a new user ID, and set a login password.
The default user ID "operator " does not have a login password set for it. Therefore, you must set a login password by
yourself according to the following instructions in order to prevent the degradation of security.
1．Reset the default user ID, and set a login password for it
2．Delete the default user ID "operator".
This section explains about the operation for the item "1" above. As for the operation for the item "2", see the section "4.4
Deleting the User ID 'operator'".
The example below explains how to reset the default user ID "operator" to the new one "newuser"and how to set a login
password.
adduser
#
Login name: newuser
********
Password:
Retype new password:
Add user'newuser'? (y/n):
#
NOTE The number of characters used in a password should be a minimum of 6 and a maximum of 129.
(If you enter more than 128 characters, the first 128 will be registered as the password.)
Note that a passowrd cannot be made up of only small letters of the English alphabet. Therefore,
use a password that also includes capital letters of English alphabet, nubmers, and/or special
characters.
(6) Execute Logout command.
Logout should be done according to the following procedure.
quit
#
logout
>
BSDI BSD/OS 3.1
login:
34
********
y
...Input "adduser" command.
...Input "newuser" as a new user ID.
...Set a login password for the new user
...Input the same password again for confirmation.
...Get back to the mode of general users.
...Execute logout command.
"newuser".
ID
QSGGS4KX10-00 5794092-2X