Hitachi GS4000 Series Quick Start Manual page 83

8.3 Deleting of Configuration Information Files
8.3 Deleting of Configuration Information Files
You can get back to the initial status of system introduction by deleting configuration information files if you need to change
the configuration of a network.
If you need an overall change of configuration information, reset it by deleting configuration information files. The deletion of
configuration information files must be done according to the following procedures.
BSDI BSD/OS 3.1
newuser
login:
Password: ********
All Rights Reserved,Copyright(C)2003,2004,Hitachi,Ltd.
*** Welcome to the System ***
GS1> enable
********
Password:
erase startup-config
GS1#
Do you wish erase current configuration file (y/n):
# exit
BSDI BSD/OS 3.1
login:
If you have to reset the configuration information, do it referring to the chapter "5 Configuration Information Setting".
NOTE All the configuration information you've input so far will be deleted if you delete a configuration
information file. Back up a configuration information file referring to the GS4000 Software Manual
Operations-Device Management Overview if you need to save the configuration information. Note
that the settings for a user ID, login password and password for adminiostrators are not deleted
even if a configuration information file is deleted.
QSGGS4KX10-00 5794092-2X
...Input a user ID.
...Input a login password.
Register yourself as an administrator.
...
...Input a password of administrator.
...Delete configuration information files.
y
...Log out of the system.
GS4000 Quick Start Guide, Revision 3
65