Hitachi GS4000 Series Quick Start Manual page 60

GS4000 Quick Start Guide, Revision 3
Case 2: Information setting in the configuration given in Example 2
Input a device name, VLAN information and an IP address of VLAN according to the following procedures.
(config)# system name GS1
vlan 100
!GS1(config)#
[vlan 100]
untagged-port 0/0-3
!GS1(config)#
[vlan 100]
!GS1(config)# router-interface VLAN100
[vlan 100]
ip 192.168.1.1/24
!GS1(config)#
[vlan 100]
exit
!GS1(config)#
!GS1(config)# vlan 200
[vlan 200]
untagged-port 0/4
!GS1(config)#
[vlan 200]
!GS1(config)# router-interface VLAN200
[vlan 200]
ip 192.168.2.1/24
!GS1(config)#
[vlan 200]
exit
!GS1(config)#
rip yes
!GS1(config)#
[rip]
!!GS1(config)# interface VLAN100
[rip interface VLAN100]
exit
!!GS1(config)#
[rip]
!!GS1(config)# interface VLAN200
[rip interface VLAN200]
exit
!!GS1(config)#
[rip]
!!GS1(config)# exit
apply
!!GS1(config)#
!GS1(config)#
NOTE The mark "!" will be shown at the beginning of a prompt if you change configuration information.
However, you can delete this mark by saving configuration information you changed. Likely, the
mark "!!" will be shown at the beginning of a prompt if you input the command which does not
need to be applied for operations immediately. In such a case, you can apply your settings for
operations immediately by inputting the "apply" command, after wich the mark "!!" will be
changed to "!".
42
...Input a device name.
...Define VLAN ID 100. (Allocate the VLAN ID 100 to VLAN100 in
Figure 5-2.)
Specify NIF No.
Specify the port No.
...Allocate the interface ports 0/0 through 0/3 to
VLAN100 as untagged ports.
...Define "VLAN100" as a name of the interface using the
layer3 function.
...Set an IP address for VLAN100.
...Define VLAN ID 200. (Allocate the VLAN ID 200 to VLAN200 in
Figure 5-2.)
...Allocate the interface port 0/4 to VLAN200.
...Define "VLAN200" as a name of the interface using the layer3
function.
...Set an IP address for VLAN200.
...Set RIP.
...Specify "VLAN100" for an interface working as RIP.
...Specify "VLAN200" for an interface working as RIP.
QSGGS4KX10-00 5794092-2X