Hitachi GS4000 Series Quick Start Manual page 59

(2) Input configuration information.
Set a device name, VLAN and an IP address of VLAN in configuration information.
Case 1: Information setting in the configuration given in
Input a device name and VLAN information according to the following procedures.
system name GS1
(config)#
vlan 100
!GS1(config)#
[vlan 100]
!GS1(config)# untagged-port 0/0-1
[vlan 100]
tagged-port 0/4
!GS1(config)#
[vlan 100]
exit
!GS1(config)#
!GS1(config)# vlan 200
[vlan 200]
untagged-port 0/2-3
!GS1(config)#
[vlan 200]
tagged-port 0/4
!GS1(config)#
[vlan 200]
!GS1(config)# exit
!GS1(config)#
NOTE The mark "!" will be shown at the beginning of a prompt if you change configuration information.
However, you can delete this mark by saving configuration information you changed.
NOTE A device name you input will be shown at the beginning of a prompt.
QSGGS4KX10-00 5794092-2X
...Input a device name.
...Define VLAN ID 100. (Allocate the VLAN ID 100 to VLAN100
in Figure 5-1.)
Specify NIF No.
Specify the port No.
...Allocate the interface ports 0/0 and 0/1 to VLAN100 as
untagged ports.
...Allocate the interface port 0/4 to VLAN100 as a tagged
port.
...Define VLAN ID 200. (Allocate the VLAN ID 200 to
VLAN200 in Figure 5-1.)
...Allocate the interface ports 0/2 and 0/3 to
VLAN200 as untagged ports.
...Allocate the interface port 0/4 to VLAN200 as a
tagged port.
GS4000 Quick Start Guide, Revision 3
41