Hitachi GS4000 Series Quick Start Manual page 38

GS4000 Quick Start Guide, Revision 3
Procedure 3.
Connect a setup terminal to GS4000-160E2.
1．
Connect a setup terminal to the CONSOLE port of BCU (BCU0) using a RS－232C cross cable.
2．
Start up a setup terminal.
3．
Start up communication software
NOTE GS4000-160E2 is pre-configured in a way that a setup terminal can be connected to a
CONSOLE port of BCU0 when it is shipped from the factory. Connect a setup terminal to a
CONSOLE port of BCU0 in case that a basic control unit is redundant.
NOTE As for the setup of communication software, see the communication software manual.
Procedure 4.
Attach an interface cable.
Attach an interface cable to an interface port.
Procedure 5.
Power on GS4000-160E2.
Set all the breakers of GS4000-160E2 to ON. GS4000-160E2 has breakers on its backside.
NOTE Set all the breakers of GS4000-160E2 to ON. However, the Basic Control Unit (BCU) detects an
abnormality in power supply and displays the STATUS CODE "22" in case that you are using
redundant power supply and only one switch is turned on.
Procedure 6.
Check LED.
When BCU0 LED of the front panel of GS4000 is lit in green, it means that GS4000 is started up.
Regarding the process GS4000 goes through until it starts up, see the section "3.2 Other Preparations".
NOTE When the BCU0 LED status is Red (Blinking) or the STATUS CODE display shows numbers 16,
20 or 22, the GS4000 is signaling a problem. Regarding troubleshooting, see Chapter 7:
Troubleshooting.
For other problems which cannot be solved there, see the manuals "GS4000･GS3000 Software
Manual, Operations - Device Management Overview" and "GS4000･GS3000 Software Manual,
Message Log Reference"
20
QSGGS4KX10-00 5794092-2X