Hitachi GS4000 Series Quick Start Manual page 51

(2) Set a time.
A time is not set at the time of initial system introduction. First of all, set a time according to the following example.
set calendar 0412011530
>
Wed Dec 1 15:30:00 2004
>
(3) Register yourself as an administrator of GS4000.
Register yourself as an administrator of GS4000.
enable
>
#
(4) Set a password of administrator.
Set a password of administrato.
password
#
Changing local password for admin.
New password: ********
Retype new password:
passwd: updating passwd database
passwd: done
#
NOTE The number of characters used in a password should be a minimum of 6 and a maximum of 129.
(If you enter more than 128 characters, the first 128 will be registered as the password.)
Note that a passowrd cannot be made up of only small letters of the English alphabet. Therefore,
use a password that also includes capital letters of English alphabet, nubmers, and/or special
characters.
QSGGS4KX10-00 5794092-2X
********
...Input a date and time (Year/Month/Date/Hour/Minutes) in
two-digit values.
...The time you set will be shown.
...Input "enable" command.
...Input "password" command.
...Input a password of administrator.
...Input the same password again for confirmation.
GS4000 Quick Start Guide, Revision 3
33