Hitachi GS4000 Series Quick Start Manual page 81

(2) Edit configuration information.
When editing configuration information, do it by resetting its related parameters after deleting them.
rip
GS1(config)#
[rip]
delete interface VLAN100
!!GS1(config)#
Are you sure? (y/n):
[rip]
!!GS1(config)# exit
apply
!!GS1(config)#
delete vlan 100
!GS1(config)#
Are you sure? (y/n):
!GS1(config)# vlan 400
[vlan 400]
!GS1(config)# untagged-port 0/0-3
[vlan 400]
router-interface VLAN400
!GS1(config)#
[vlan 400]
!GS1(config)# ip 192.168.1.1/24
[vlan 400]
exit
!GS1(config)#
!GS1(config)# rip yes
[rip]
interface VLAN400
!!GS1(config)#
[rip interface VLAN400]
!!GS1(config)# exit
[rip]
exit
!!GS1(config)#
apply
!!GS1(config)#
!GS1(config)#
NOTE There are parameters which must be deleted in the specific order. For the case above,
the deletion of VLAN settings must be done after that of RIP settings.
QSGGS4KX10-00 5794092-2X
y
y
Specify the NIF No.
Specify the port No.
...Enter into the RIP mode.
...Delete the RIP settings for VLAN100.
...Apply the RIP settings you deleted for operation.
...Delete the settings for VLAN100.
...Define VLAN ID 400.
...Allocate the interface ports 0/0 through 0/3 to VLAN400 as
untagged ports.
...Define "VLAN400" as a name of the interface using the layer3
function.
...Set an IP address for VLAN400.
...Set RIP.
...Specify VLAN400 for an interface working as RIP.
...Apply RIP settings for operation.
GS4000 Quick Start Guide, Revision 3
63