Siemens LMV5 Quick Start Manual page 18

AZL5 Display 2-2
The AZL5 is designed to be mounted through the face of an electrical enclosure. This is
accomplished by an accurate cut-out, which is usually in the door of the enclosure. The AZL5 has
one screw on the top and one on the bottom that engage small plastic tabs that will swing out and
pull to the front when the screw is tightened, and will retract and push to the back when loosened.
This facilitates easy removal and replacement of the AZL5 since it is designed to be taken out of the
enclosure face and held in the hands for set up / commissioning. When properly installed, the AZL5
will hold the sheet metal of the enclosure between the plastic tabs and ridge which holds the AZL5
to the enclosure gasket.
The connector shown in Figure 2-2.1 is for the connection of a laptop computer.
Note that the CANbus connector, (not shown) plugs into the bottom of the AZL5. The CANbus
connector would not be seen from the front when the AZL5 is mounted, but does require
approximately 2.5" below the bottom of the AZL5 to clear the connector and the CANbus cable.
Please see Section 10-1 for specifications.
Figure 2-2.1 AZL5 Dimensions (inches)
LMV5 QSG Rev 4 Sec 2 Pg 2 www.scccombustion.com