Siemens LMV5 Quick Start Manual page 58

Typical Settings
Although the LMV5 has many parameters that can be adjusted, most burners / boilers only need a
few parameters adjusted to operate properly.
If the burner / boiler has been shop tested, the number of parameters that must be adjusted is
reduced even further.
The following table lists the parameters that must be set on an un-programmed LMV51 in order to
operate most simple non-FGR burner / boiler safely.
Common to Both Fuels
Auto/Manual/Off
1 AirActuator
(address)
2 AirActuator
(rotation direction)
IgnitionPosAir
PrepurgePosAir
OperatRampMod
SetLoad
LC_OptgMode
StandardParam
SD_ModOn
SD_ModOff
TimeNoFlame
ForcedIntermit
SensorSelect
MRangePressSens
MRangeTempSens
MeasureRangePtNi
Ext Inp X61 U/I
SetpointW1
Note: The index at the beginning of Section 4-2 shows the above parameters in bold type.
LMV5 QSG Rev 4
Table 4-1.1 Necessary LMV51 Parameters
DUAL FUEL Example
Gas Burner
FuelTrainGas
2 GasActuator
2 GasActuator
IgnitionPosGas
CurveParams Gas
MinT_PrepurgeGas
PrepurgeTmeGas
SafteyTme1Gas
SafteyTme2Gas
PS-VP/ CPI
Gas Burner
StartPointOp
Hot water (not applicable to Steam)
TL_Thresh_Off and TL_SD_On
Sec 4
Light Oil Burner
3 OilActuator
(address)
3 Oil Actuator
(rotation direction)
CurveParams Oil
MinT_PrepurgeOil
OilPumpCoupling
Light Oil Burner
Pg 2 www.scccombustion.com
FuelTrainOil
(address)
(rotation direction)
IgnitionPosOil
PrepurgeTmeOil
SafteyTme1Oil
SafteyTme2Oil
IgnOilPumpStart
OilPressureMax
StartPointOp